LT6600CS8-10#PBF

LT6600CS8-10#PBF combines a fully differential amplifier with a 4th order 10MHz lowpass filter approximating a Chebyshev frequency response. Most differential amplifiers require many precision external components to tailor gain and bandwidth. In contrast, with the LT6600-10, two external resistors program differential gain, and the filter’s 10MHz cut-off frequency and passband ripple are internally set. The LT6600-10 also provides the necessary level shifting to set its output common mode voltage to accommodate the reference voltage requirements of A/Ds. Using a proprietary internal architecture, the LT6600-10 integrates an antialiasing filter and a differential amplifier/driver without compromising distortion or low noise performance. Typical applications are high-speed ADC antialiasing and DAC smoothing in networking or cellular base station applications, high-speed test and measurement equipment, medical imaging, and drop-in replacement for differential amplifiers.

• Programmable differential gain via two external resistors
• Adjustable output common mode voltage, fully differential inputs and outputs
• 0.5dB ripple 4th order lowpass filter with 10MHz cut-off
• Compatible with popular differential amplifier pinouts
• Filter gain temperature coefficient is 780ppm/C typ (fIN=260KHz, VIN=2VP-P)
• Noise is 56μVRMS typ (noise BW=10KHz to 10MHz, RIN=402ohm, TA=25°C)
• Input bias current is -40μA typical (average of pin 1 and pin 8, TA=25°C)
• Differential offset drift is 10μV/°C typ (TA=25°C, VS=5V (V+=5V, V–=0V), RIN=402 ohm, and RLOAD=1K)
• 8-lead plastic SO package
• Temperature rating range from 0°C to 70°C

Notes

ADI products are only authorized (and sold) for use by the customer and are not to be resold or otherwise passed on to any third party